Finding a compressor with a hard start kit already on it. Compressor wouldn’t start
#hvac
#carrier
#compressor

Subscribe to Channel:

This video by HVAC GUY was liked: 169 times

If you like this video by HVAC GUY, please support their CHANNEL by clicking on the SOURCE link below and Subscribe.

SOURCE

————————————–

Featuring Your Videos:

By featuring your videos on our blog, your videos will receive hundreds of views daily from our website visitors, you get a backlink to your channel for followers to subscribe to your channel. This is a win/win for SEO for both of us. If you would like your videos or channel highlighted and premiered on our blog for FREE, please contact us.

However, if you no longer want us to premier your channel, and want us to remove your video and not feature your channel anymore, please contact us.

Video Post Disclaimer:

The information contained in the multimedia content (“Video Content”) or post content in general, represents the views and opinions of the original creators of such Video Content or post, and does not necessarily represent the views or opinions of KASRefrigeration.com. The mere appearance of Video Content or the post on the Site does not constitute an endorsement by KASRefrigeration.com or its affiliates of such Video or Post Content. 

The Video Content or Post has been made available for informational and educational purposes only. KASRefrigeration.com does not make any representation or warranties with respect to the accuracy, applicability, fitness, or completeness of the Video or Post Content. KASRefrigeration.com does not warrant the performance, effectiveness or applicability of any sites listed or linked to in any Video Content or Post.

Affiliate Disclosure:

This post and description may also contain some affiliate links, which means that the post creator may receive a small commission at no extra cost to you if you click on some of the product links and decide to make a purchase. This channel is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com

Copyright Issue:

If you find any of your copyrighted material in this post or video, please contact us, so we can resolve the issue.

All rights reserved by respective owners.

16 thoughts on “No cooling, Compressor stuck

  1. TechFive says:

    You try hard to get them going. That's good. I would have checked mf then locked rotor amps and called it bad compressor. If it was my house then I would have removed fan, push in disconnect then immediately hit it with a hammer so I can have cold air until a new comp installed. Works great deal of the time

  2. Jeremy McGuire says:

    A total of 1.5ohms from run to start seems very low, but the LRA spec of 117amps is close to what you measured. That's a weird compressor. Alost like it's designed to trip breakers

  3. Hidden Resolve says:

    Copeland app works good for verifying winding resistances. I have seen stalactites on factory joints before, even pieces of rod. I had a compressor that was stuck installed 4 months ago that didnt even get its first run yet. Suprised a Copeland is stuck, I usually have to deal with the LGs that take a crap all the time.

Leave a Reply

Your email address will not be published. Required fields are marked *