in the all I had to do was remove one pen from the time clock too many defrost one pin at 6;00am one pin at 6;00pm for 40 minutes each in this case the box was a hill phoenix call tech support tell them the model that you have and they will give you recommendations for defrost time the box is what you want to know what you have that is what is important to know

Subscribe to Channel:

This video by Russ Sandan was liked: 196 times

If you like this video by Russ Sandan, please support their CHANNEL by clicking on the SOURCE link below and Subscribe.

SOURCE

————————————–

Featuring Your Videos:

By featuring your videos on our blog, your videos will receive hundreds of views daily from our website visitors, you get a backlink to your channel for followers to subscribe to your channel. This is a win/win for SEO for both of us. If you would like your videos or channel highlighted and premiered on our blog for FREE, please contact us.

However, if you no longer want us to premier your channel, and want us to remove your video and not feature your channel anymore, please contact us.

Video Post Disclaimer:

The information contained in the multimedia content (“Video Content”) or post content in general, represents the views and opinions of the original creators of such Video Content or post, and does not necessarily represent the views or opinions of KASRefrigeration.com. The mere appearance of Video Content or the post on the Site does not constitute an endorsement by KASRefrigeration.com or its affiliates of such Video or Post Content. 

The Video Content or Post has been made available for informational and educational purposes only. KASRefrigeration.com does not make any representation or warranties with respect to the accuracy, applicability, fitness, or completeness of the Video or Post Content. KASRefrigeration.com does not warrant the performance, effectiveness or applicability of any sites listed or linked to in any Video Content or Post.

Affiliate Disclosure:

This post and description may also contain some affiliate links, which means that the post creator may receive a small commission at no extra cost to you if you click on some of the product links and decide to make a purchase. This channel is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com

Copyright Issue:

If you find any of your copyrighted material in this post or video, please contact us, so we can resolve the issue.

All rights reserved by respective owners.

15 thoughts on “Troubleshooting commercial refrigeration

  1. 2020 Subaru WRX 6spd Manual says:

    I see he's working on a hill phoenix unit. I'm in the process of installing seven remoted hill phoenix systems. The boxes are sort of crappy but the condensers use Copeland compressors. A note, if the hill phoenix freezer you're installing uses a carel control, the wiring diagram will suck.

  2. Bobby M says:

    First you pump down ONE sys not the whole rack and dump it in on the liquid side. Since its pumped down it won't be high pressure. Second, if you always have flood back sounds like you need to adjust some valves "Mr. Elite"

  3. Jorge Arteaga says:

    Need help troubleshooting commercial refrigerator, already filled system but compressor still doesn’t run. I ran compressor independently and the compressor spins but the system has no pressure so compressor won’t run as intended. The system has no leaks

  4. Tree Frogs says:

    One way to check the low pressure control to make sure it's on calibration you could pick out one end of the low pressure control with a quarter inch nut put it on the gauge I'm set the pressure on the gauge on coordination with setting increase the pressure probably with CO2 see if it come on on the right pressure under pressure control and gauge must be read the same if not calibrated 95% of the time it's off calibration this is a very important test especially for a freezer box on a pump down system

  5. Tree Frogs says:

    leaking solenoid will freeze up inside this is one sign short cycling leaking discharge valve on the compressor this is another one I hope there's a check while on a discharge line

Leave a Reply

Your email address will not be published. Required fields are marked *